Is the most advanced, easiest to use machine of its This warranty is in addition to your statutory and other legal rights. If you purchase this product from any other source, your purchase is “AS IS,” which means Oreck grants you no warranty, and that you, not Oreck, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects. Oreck’s warranty is valid only if you retain proof of purchase from Oreck or an Oreck Authorized Retail Dealer for this product. Oreck does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product. This warranty does not apply to any part subjected to accident, abuse, alteration, misuse, damage caused by act of God, the use of voltages other than indicated on the serial number displayed on this product or service of this product by other than Oreck or a participating Factory Authorized Service Center. Brushes, pads, drive blocks and other parts are subject to normal wear and are not covered by this warranty. Note: If the unit is used commercially, a (1) one year overall warranty applies. ORB555MC models carry a (5) five year limited motor warranty which applies to residential use. ORECK MANUFACTURING COMPANY: (Oreck 21180 Johnson Road Long Beach, MS, USA 39560 gives you the following warranty for this product only if it was originally purchased for use, not resale from Oreck or an Oreck Authorized Retail Dealer.) Oreck will repair or replace, free of charge, to the original purchaser, any part that is found to be defective in material or workmanship within one (1) year of the date of purchase. There are no user serviceable parts inside. All other servicing should be performed by an authorized service center. Lubrication: The Orbiter motor bearings are factory lubricated and sealed. A little care will keep your Orbiter looking like new. Clean housing and bumper with damp cloth after each use. After each use, remove wax or cleaning solutions. Store your machine in the upright position. The bristles may be damaged due to the weight of the machine. Wrap your cord loosely around the two hooks on the handle. Dropping, unreasonable bumping or rough handling may result in damage to the balanced counter-weight system. Before completing any of the following procedures for the first time, test a small hidden area.Ĭare of your Oreck Floor Machine: This is a precision machine. IMPORTANT - Always wear shoes when using your Orbiter. The Orbiter's perfectly balanced counter-weight system gives smooth and easy action with fingertip control. The patented “T” handle feature gives you complete control. Grasp the unique “T” handle and glide the machine across the floor in a back and forth motion. Before turning the machine on, be sure there is a pad or brush in place on the machine. BE CAREFUL that the switch is in the OFF (O) position before you plug the electric cord into the outlet. On (I) - Off(O) is printed on the switch. It has been designed to be conve- niently activated. The Orbiter's on-off switch is located on the handle.
Lay machine on its back and pull brush or pad holder off the round holder pan. Place the brush or drive pad holder over the round brush holder pan making sure it is in place.ĬAUTION: NEVER put the brush or pad holder on the machine by placing it on the floor and moving the running machine over it, or by placing the machine over the brush or pad holder and then starting the motor. Lay the floor machine on its back with the handle lying on the floor.
0 kommentar(er)
